New Raiders gun belt
Posted: Sat Oct 12, 2024 9:52 am
For some time now I've wanted to exchange my old gun belt's buckle and keeper to a full brass version. I know brass is not really SA, but I have a thing for brass objects. I kept an eye out for a set that I would like and last week I finally found them both at the same shop as some roohide and ordered them.
When I got them though, they did not fit my old belt. I had cut it at 40 mm width and the holes were to small. Rather than start cutting it up, I took the opportunity to make a new one entirely. Anyway the old one was much too dark for my taste. I took care to dye it a lighter shade of brown and after finishing it, I played around a bit to give it some nice striations. I am really liking the way it turned out. I am hoping the brass is not laquered so that it will age nicely.
Here you see a close up of the striations:
And here is the setup with my recent Raiders holster and my old whip holder:
Cheers,
Bear
When I got them though, they did not fit my old belt. I had cut it at 40 mm width and the holes were to small. Rather than start cutting it up, I took the opportunity to make a new one entirely. Anyway the old one was much too dark for my taste. I took care to dye it a lighter shade of brown and after finishing it, I played around a bit to give it some nice striations. I am really liking the way it turned out. I am hoping the brass is not laquered so that it will age nicely.
Here you see a close up of the striations:
And here is the setup with my recent Raiders holster and my old whip holder:
Cheers,
Bear