Raiders ribbon stitch points

In-depth discussion of the Fedora of Indiana Jones and all other hats appearing in the Indiana Jones movies

Moderators: Indiana Jeff, Dalexs

Post Reply
Heyjude7
Dig Leader
Dig Leader
Posts: 585
Joined: Sun Feb 12, 2006 11:03 am
Location: Everett, WA

Raiders ribbon stitch points

Post by Heyjude7 »

For the raiders ribbon, where are the usually stitch points to hold on the ribbon? I have looked at the screenused one over and over and I think I see a few but my eyes play tricks at times! The stitch points look like mid ribbon about 1/2 in up from brim
Thanks in advance ladies and gents!
Regards,
Jude
User avatar
Ridgerunner58
Dig Leader
Dig Leader
Posts: 695
Joined: Tue Jun 02, 2009 4:40 pm
Location: Between the Edge of Nowhere and the Edge of Somewhere.

Re: Raiders ribbon stitch points

Post by Ridgerunner58 »

What you're describing is the "floating" stitches that good hatmakers avoid using.

Good hatters stitch the ribbon by hand right at the very bottom so as to conceal the stitches as much as possible.

The floating stitches on, for example an Adventurebilt Legacy, a Penman Cairo or a Garrison Cairo tacj the ribbon on with stitches placed about every 3" located around 1/2" above the bottom edge of the ribbon. (Yes I measured - but no, it's not "mid-ribbon" because the ribbon is about 1 1/2" wide.) :TOH:
Last edited by Ridgerunner58 on Thu Mar 26, 2015 9:56 am, edited 1 time in total.
Heyjude7
Dig Leader
Dig Leader
Posts: 585
Joined: Sun Feb 12, 2006 11:03 am
Location: Everett, WA

Re: Raiders ribbon stitch points

Post by Heyjude7 »

Did the raiders fedira have floating stitches?
darthjones
Archaeologist
Archaeologist
Posts: 318
Joined: Fri Mar 31, 2006 4:29 am

Re: Raiders ribbon stitch points

Post by darthjones »

Yes. The Raiders hero was a beautiful mess.

If you look at the Adventurebilt Legacy you can see them reproduced to the most humanly possible degree I think.
Post Reply