Page 1 of 1
rebashing
Posted: Tue Jul 29, 2008 1:40 pm
by okayletsrock
hey guys, i just purchased a JPD rabbit used off indy lounge. since used it already had a bash in it etc. but my question is is there a way to rebash it? i want to put the SOC turn into it. but since its already bashed putting the turn puts the front pinch over my right eye.
so if you could help me out with some steps i need to take to get rid of the old bash and put my own in id appreciate it
Posted: Tue Jul 29, 2008 1:44 pm
by Indiana G
spray it down with distilled water then push out the crease so that it's as "open crowned" as possible. let it dry fully. rebash
Posted: Wed Jul 30, 2008 3:19 pm
by Chewbacca Jones
Hey, G. That's my line!
Posted: Wed Jul 30, 2008 3:53 pm
by okayletsrock
it still wants to fall into place of the old bash... i stuffed it full of tshirts and all still nothing
Posted: Wed Jul 30, 2008 5:00 pm
by Indiana G
she may have no stiffener left in the felt. tough call on that one. you can try the spray on stiffener while she's open crowned so that it won't collapse on itself....but to tell you the truth, i've never had much luck with that stuff. by that point in time, i'm usually looking for a reblock......OH JIMMY........WHATCH DOIN?
Posted: Wed Jul 30, 2008 6:21 pm
by ichnob
Yeah, I'd recommend a re-block as well. As Indiana G stated, get in touch with Jimmy of Jimmy Pierce Designs. Or you can ask BendingOak as well, since he provides re-blocking services.
Posted: Wed Jul 30, 2008 6:32 pm
by okayletsrock
alright thanks for the replies gentleman
Posted: Thu Jul 31, 2008 5:15 am
by Long John Silver
I've rebashed my Fed 4 four times now because I didn't read thoroughly enough about the "turn" (i.e. I was a noob to wearing/bashing hats).
First time - bashed it without the turn
Second time - bashed it too far with the turn
Third time - got the turn right but pinched the top of the front crease too low.
Fourth time - finally got it where I wanted it.
For what it's worth, I used warm water on the creases every time and I let it dry between. Stiff as a board and doesn't show any of the old creases.
Awesome hat I must say...
Posted: Thu Jul 31, 2008 4:08 pm
by Chewbacca Jones
Before you go for a reblock, try wetting it again, and rebashing while it's still wet. Hold it gently in place for a while, too. That might help.
Posted: Thu Jul 31, 2008 4:15 pm
by okayletsrock
well i finally got it to stick with the bash, it still needs some tweaking. ***** cuz my bash is nowhere near as good as raging blues' was -_-"
