Club Obi Wan

After some trial and error thought it was time to do some fine tuning of the TOD pockets.

I present you my drawing and revised specs below.

http://img88.imageshack.us/img88/5605/w ... etsed7.jpg


Right Pocket- 3 inches from the zipper seam (edge of jacket).
2.5 inches from bottom.
Width of pocket: 5.5 inches.
Length of pocket (including pocket flap) :6 inches
Slightly scalloped pocket flap.
Pocket flap length in middle of flap, 2.8 inches
Side entry hand warmer pocket
Nickel snap.

Left Pocket- 3 inches from edge of storm flap.
2.5 inches from bottom.
Width of pocket: 5.5 inches.
Length of pocket (including pocket flap) :6 inches.
Slightly scalloped pocket flap
Pocket flap length in middle of flap, 2.8 inches
Side entry hand warmer pocket
Nickel snap.

PLATON, you deserve a medal for your contribution to Screen accuracy

Wow! These are the EXACT specs I used on this jacket: viewtopic.php?t=28741

Kind regards,
Magnoli

"Give me five"

A couple of pics to try and help. I think your pockets are marginally too small and the flap too deep. But that may be just me.

A couple of pics to try and help. I think your pockets are marginally too small and the flap too deep. But that may be just me.

I will give you that for the flap judging from these pics. I took my measurements for the flap from other pictures and it was dead on.

But for the pockets being small that doesn't help. You gotta say what size you think is the right one.

Keep in mind that I don't say that mine is correct. I 'm just saying what measurements I would use if I ordered TOD.