Hello there!
Considering purchasing a Fed IV, and am a bit apprehensive about the creasing. The Vendors page states this:
For those who may be apprehensive of doing this, we have a tutorial and a whole message board in place to assist you.
Can someone help me find this thread? What would be the best way to get a Raiders bash?
Thanks.
Akruba bash
Moderators: Indiana Jeff, Dalexs
-
- Dig Leader
- Posts: 459
- Joined: Tue Jan 15, 2013 8:06 am
- Location: Maryland, USA
- Contact:
Re: Akruba bash
Can't find the Hattery tutorial, but here are a few other YouTube tutorials that should help (including a few from expert Herbert Johnson hatter Michelle):AnObtainerNamedIndy wrote:Hello there!
Considering purchasing a Fed IV, and am a bit apprehensive about the creasing. The Vendors page states this:
For those who may be apprehensive of doing this, we have a tutorial and a whole message board in place to assist you.
Can someone help me find this thread? What would be the best way to get a Raiders bash?
Thanks.
https://www.youtube.com/watch?v=UoDL0jmbEuw" onclick="window.open(this.href);return false;
https://www.youtube.com/watch?v=6teKY8gGHfM" onclick="window.open(this.href);return false;
https://www.youtube.com/watch?v=_8CBgOFFzZA" onclick="window.open(this.href);return false;
https://www.youtube.com/watch?v=GKb2BzfiW5o" onclick="window.open(this.href);return false;
Creasing an Indy style isn't hard. Just take your time, check the mirror often to be sure you're getting the center dent actually centered, and you should be fine.
Solid quality felt like Akubra uses on the Fed IV is pretty forgiving, tough to ruin, and you can always start over and do it again if it doesn't come out quite right.
-
- Dig Worker
- Posts: 20
- Joined: Sun Feb 02, 2020 5:04 am
Re: Akruba bash
Thank you!Howard Weinstein wrote:Can't find the Hattery tutorial, but here are a few other YouTube tutorials that should help (including a few from expert Herbert Johnson hatter Michelle):AnObtainerNamedIndy wrote:Hello there!
Considering purchasing a Fed IV, and am a bit apprehensive about the creasing. The Vendors page states this:
For those who may be apprehensive of doing this, we have a tutorial and a whole message board in place to assist you.
Can someone help me find this thread? What would be the best way to get a Raiders bash?
Thanks.
https://www.youtube.com/watch?v=UoDL0jmbEuw" onclick="window.open(this.href);return false;
https://www.youtube.com/watch?v=6teKY8gGHfM" onclick="window.open(this.href);return false;
https://www.youtube.com/watch?v=_8CBgOFFzZA" onclick="window.open(this.href);return false;
https://www.youtube.com/watch?v=GKb2BzfiW5o" onclick="window.open(this.href);return false;
Creasing an Indy style isn't hard. Just take your time, check the mirror often to be sure you're getting the center dent actually centered, and you should be fine.
Solid quality felt like Akubra uses on the Fed IV is pretty forgiving, tough to ruin, and you can always start over and do it again if it doesn't come out quite right.
-
- Dig Leader
- Posts: 459
- Joined: Tue Jan 15, 2013 8:06 am
- Location: Maryland, USA
- Contact:
Re: Akruba bash
You're very welcome