TOD JACKET POCKETS PLATON SPECS

PLATON · Post by **PLATON** » Sun May 04, 2008 5:32 pm

After some trial and error thought it was time to do some fine tuning of the TOD pockets.

I present you my drawing and revised specs below.

http://img88.imageshack.us/img88/5605/w ... etsed7.jpg

Right Pocket- 3 inches from the zipper seam (edge of jacket).
2.5 inches from bottom.
Width of pocket: 5.5 inches.
Length of pocket (including pocket flap) :6 inches
Slightly scalloped pocket flap.
Pocket flap length in middle of flap, 2.8 inches
Side entry hand warmer pocket
Nickel snap.

Left Pocket- 3 inches from edge of storm flap.
2.5 inches from bottom.
Width of pocket: 5.5 inches.
Length of pocket (including pocket flap) :6 inches.
Slightly scalloped pocket flap
Pocket flap length in middle of flap, 2.8 inches
Side entry hand warmer pocket
Nickel snap.

starks_6 · Post by **starks_6** » Sun May 04, 2008 6:05 pm

PLATON, you deserve a medal for your contribution to Screen accuracy

Post by **Indy Magnoli** » Sun May 04, 2008 8:55 pm

Wow! These are the EXACT specs I used on this jacket: viewtopic.php?t=28741

Kind regards,
Magnoli

PLATON · Post by **PLATON** » Mon May 05, 2008 5:15 am

"Give me five"

Kt Templar · Post by **Kt Templar** » Mon May 05, 2008 5:19 pm

A couple of pics to try and help. I think your pockets are marginally too small and the flap too deep. But that may be just me.

PLATON · Post by **PLATON** » Tue May 06, 2008 6:51 am

A couple of pics to try and help. I think your pockets are marginally too small and the flap too deep. But that may be just me.

I will give you that for the flap judging from these pics. I took my measurements for the flap from other pictures and it was dead on.

But for the pockets being small that doesn't help. You gotta say what size you think is the right one.

Keep in mind that I don't say that mine is correct. I 'm just saying what measurements I would use if I ordered TOD.